If something is not working correctly after you have completed the steps above to install Bamboo, please check for known Bamboo issues and try troubleshooting your upgrade as described below: Check for known issues and troubleshoot the Bamboo installation This can be beneficial to other community members reading the thread.Choose the relevant instructions for your operating system:ģ. Please remember to click “Mark as Answer” on the post that helps you, and to click “Unmark as Answer” if a marked post does not actually answer your question. Please have a try to look at this article perhaps it may help you:
There are some components that probably not updated correctly from the last update,you may try to download this language pack: There are something that you may check again as august 2012 require SP1,ġ) If you have additional lang packs installed, make sure to install SP1 for each of them, and have a download from Ģ) Make sure, that project server, sharepoint server both at least SP1 Please click "Propose As Answer" if a post solves your problem or "Vote As Helpful" if a post has been useful to you. I've also tried re-downloading the packages on the off chance that something went wrong in the download - this made no difference.
Upwards of an hour, so skipping the check doesn't actually solve the problem. Here, however, that allows the installation to proceed, but it finishes the entire installation in just a few seconds (in other words, no files are actually copied, and no upgrade is every triggered when running psconfig) - normally this operation takes I have tried using the workaround described Note: There are NO language packs installed, only the default English Language (1033) has ever been used on this server. I then retried to apply the October 2012 CU, with the same I have a SharePoint 2010 environment which I am getting the error message The expected version of the product was not found on the system. This one worked successfully, and the server was then on the June 2012 CU.
I've tried to reboot the server, run both the foundation update, and the server (both with the same error message results), and even uninstalled Office 2010 (which happened toīe on the server for development purposes), hoping that perhaps it was an Office component that was failing - same results afterwards.Īs none of this was working, I tried instead to download another CU (June 2012 CU) and apply it to the server. The server has (for a long time) had SharePoint 2010 SP1Īpplied, and in fact was on Feb 2012 CU, prior to attempting to run this. I have a SharePoint 2010 environment which I am getting the error message "The expected version of the product was not found on the system" when trying to apply the October 2012 CU.